How to measure your garage door opening
Five measurements, a tape measure and five minutes. What each one tells a fitter, and why they still measure again before ordering.
Width (A): between the piers
From inside the garage, measure across the opening between the brick piers, in millimetres. Do it at the top, the middle and the bottom, and note all three. The smallest is the one that matters.
Height (B): floor to lintel
Measure from the floor to the underside of the lintel, the beam across the top of the opening, on both sides. Garage floors often slope, so they may differ.
Headroom (C): lintel to ceiling
Measure from the underside of the lintel up to the ceiling, or to the lowest thing in the way, such as a beam, a light or a pipe. Roller and sectional doors need room here.
Side room (D and E): beside the opening
Measure from each side of the opening to the nearest wall or obstruction inside the garage. Sectional doors and roller doors run in tracks here.
Depth: how far back it's clear
Measure from the opening back along the ceiling to the first thing in the way. Up-and-over and sectional doors, and most motors, need this space clear.
Your measurements tell a fitter which doors will fit before anyone visits. They'll measure again before ordering, but knowing the five numbers below saves a wasted visit and shows straight away if your opening is awkward.
Use a metal tape measure and write everything in millimetres. Measure from inside the garage with the door open if you can.